Ineco Tube Bending Machinery

Home > Tube Bending Machinery > Ineco Tube Bending Machines

QB-50 VDM, QB-50 VDE

QB50 available in either VDM (shown) using a manual hand wheel for positioning of the CB (counterbend die), or VDE model which incorporates motorized CB die positioning.
Maximum capacity: up to 2" OD tube (mild steel, .125" wall thickness). Wide range of bend radii available from 3/8" to 8-3/4" CLR.
Tooling available to bend round, square, rectangular tube, and profiles or special shapes.
Variable bending speed: adjusted by potentiometer on control panel (>/=11.5 seconds for 180°). Allows operator to set required speed for various material; i.e stainless and chromoly require slow speed settings.
Microprocessor Control Unit: bending angle, springback factor, and zero position of counterbend die shaft (VDE model only) are fully programmable and monitored thru the control panel.
User friendly programming: easy step by step method. Capable of storing up to 10 sequential bends.
Electronic overload device: automatically protects the mechanical system from possible damage caused by oversized material and / or excessive bend speed.
Multilanguage control panel with backlit LCD display enhances ease of operating and programming.
Low maintenance: requires lubrication of counterbend die only.
Quick change tooling.
Portable: built in wheels and extractable handles.
Available in single phase, or three phase with multiple voltage settings.

Maximum capacity: up to 3" OD (.125" wall); bend radii up to 15-3/4".
QB76 available in either VDM using a manual hand wheel for positioning of the CB (counterbend die), or VDE model (shown) which incorporates motorized CB die positioning.
Variable bending speed: adjusted by potentiometer on control panel (>/=21.5 seconds for 180°). Allows operator to set required speed for various material; i.e stainless and chromoly require slow speed settings.
QB-76 VDE/S model available when higher speeds are required; capacity is same, bend speed is 2.5 times faster.
Tooling available to bend round, square, rectangular tube, and profiles or special shapes.
Microprocessor Control Unit: bending angle, springback factor, and zero position of counterbend die shaft (VDE model only) are fully programmable and monitored thru the control panel.
User friendly programming: easy step-by-step method. Capable of storing up to 10 sequential bends.
Electronic overload device: automatically protects the mechanical system from possible damage caused by oversized material and/or excessive bend speed.
Multilanguage control panel with backlit LCD display enhances ease of operating and programming.
Low maintenance: requires lubrication of counterbend die only.
Quick change tooling.
Portable: built in wheels and extractable handles.
Available in single phase, or three phase with multiple voltage settings.